The safety recommendations outlined in this section should be read and understood before operating this machine.Keep this information for future reference. 1.To prevent the possibility of electronic shock,do not allow any fluids ins- 1、Features 3、Operation Instruction ide or around the machine. 1)The right way to load 2.Do not operate machine for any purpose other than its intended use.
Description & Operation Description & Operation 2.2.1 Model Display /controlling Panel 2.3 External display The external display show the same number UV MG IR MT as in the controlling panel LED or LCD. COUNT The external display is showed to the bank Customer.
Description & Operation Operation Instruction 3.2 Working modes description ■Photo 3.2.4 3.2.4 Mode Of Counting And Detecting ■Photo 3.2.1 3.2.1 Mode of counting and detecting UV MG IR Bills By MT bills by UV MG IR MT In the machine ,press MT, the machine COUNT In the machine ,press UV, the machine is into MT detecting mode, it check fake...
Page 6
Operation Instruction Operation Instruction 3.3 Error -Message Dispaly ■Photo 3.2.7 3.2.7 Mode Of Adding Count Code No. Malfunction causes Solutions UV MG IR MT Press ADD button,the machine is into The left counting sensor is broken or dirty To change a new one or clean it add counting mode, it adds up the last COUNT The right counting sensor is broken or dirty...
Operation Instruction Operation Instruction 3.6 Troubleshooting Operational Problems 3.4 The Way To Adjust The Up / Down Screw Note: when counting and detecting is not accurate, please check the machine as following The power line cord is The fuse is worn out? The power switch is on ? Due to long transportation and long use, connected well?
Warning Maintenance Notice Cleaning Of The Machine Maintenance Notice 1. The machine must be safely connected with the power source. Warning:Before doing any cleaning, turn the power switch off and disconnect the power cord to from the machine 2.The machine must be kept in dry and ventilated place to avoid strong sunlight.
Need help?
Do you have a question about the PRMC720 and is the answer not in the manual?
Questions and answers
how do I put that piece inside