Silvercrest SSJBE 300 A1 Operating Instructions Manual page 47

1) Place the sieve tray
on the appliance base
tray
NOTE
► Make sure that the black rubber plug on the bottom of the sieve tray
closes the rear end of the outlet for fruit pulp and vegetable mash
is inserted. This should only be removed for cleaning!
■ If you want to juice fruit/vegetables:
–
Place the removable sieve frame
frame
bottom of the sieve tray
–
Place the sieve
the upper edge of the sieve
on the sieve tray
■ If you want to make sorbets:
–
Place the sorbet attachment
the upper edge of the sorbet attachment
ing curvature on the sieve tray
is positioned in front of the outlet of the sieve tray
2) Place the transport screw
it down at the same time so that it clicks into place. Ensure that it is firmly
seated before continuing with the assembly.
3) Place the lid
points to the
4) Turn the lid
on the sieve tray
NOTE
► This appliance has a safety device. The appliance can only be operated
when the lid
5) Push the container for fruit pulp and vegetable mash
fruit pulp and vegetable mash
NOTE
► When using the sorbet attachment
vegetable mash
6) Push the juice container
7) Open the stopper
SSJBE 300 A1
onto the appliance base
fit into the three slots on the underside of the sieve
.
back and forth to see whether the gear on the inside at the
into the removable sieve frame
.
onto the drive shaft
onto the sieve tray
marking on the sieve tray
clockwise until the
and clicks firmly into place.
is correctly fitted.
is not required.
under the juice outlet
so that the juice can flow into the juice container
so that the three catches
into the sieve tray
turns.
must lie in the corresponding curvature
into the sieve tray
must lie in the correspond-
. The outlet of the sorbet attachment
, turn it a little and press
so that the marking on the lid
.
marking points towards the
(see fig. A).
, the container for fruit pulp and
(see fig. A).
and
. Turn the sieve
. The curvature at
. The curvature at
.
marking
under the outlet for
.
GB │ IE │ 43 ■