Sealey AJS10000 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instructions protection
1. safety
WarninG! ensure correct air pressure is maintained and not exceeded.
‰
WarninG! only attachments and/or adapters supplied by the sealey shall be used.
‰
WarninG! do not connect two jacks to one control valve. operating the jacks in this way can cause of lossof control during raising and
‰
lower the vehicle.
WarninG! do not attempt to raise a partially filled tanker or transport containing an unrestrained load. A sudden load shift can occur
‰
causing dangerous tilting or toppling of the vehicle
WarninG! turn off air supply and de-pressurise the control nozzle before removing the pump unit from any installation or mobile system.
‰
failure to comply with this instruction may damage the unit and will invalidate your warranty.
disconnect jack from air supply before changing parts, servicing or performing any maintenance.
9
Keep air hose away from heat, oil and sharp edges. check air hose for wear before each use, and ensure that all connections are secure.
9
ensure the jack is in sound condition and good working order. take action for immediate repair or replacement of damaged parts.
9
use genuine parts only. unauthorised parts may be dangerous and will invalidate the warranty.
9
use jack on level and solid ground, preferably concrete. Avoid tarmacadam as jack may sink in.
9
Place wedges under wheels of vehicle.
9
ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear (or "Park" if automatic).
9
ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc., to allow for vehicle tilting.
9
only place jack under those lifting points recommended by vehicle manufacturer (see vehicle handbook).
9
check that the jacking point is stable and centred on the jack saddle and is free from grease and oil.
9
locate the jack in a suitable, well lit work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
use a qualified person to maintain or repair the jack's hydraulic system.
9
ensure there are no passengers in the vehicle.
9
ensure all non-essential persons keep a safe distance whilst the jack is in use.
9
ensure that there are no persons or obstructions beneath the vehicle before lowering.
9
When not in use disconnect jack from the air supply, and store, fully lowered, in a safe, dry, childproof area.
9
do not allow untrained persons to operate the jack.
8
do not operate the jack if parts are missing or damaged.
8
do not exceed the rated capacity of the jack.
8
do not allow the vehicle to move while supported by the jack.
8
do not jack the vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
8
do not work under the vehicle until axle stands have been correctly positioned.
8
do not use the jack for purposes other than that for which it is intended.
8
do not adjust the safety overload valve.
8
do not apply your body weight to the handle during jacking. the handle is only for moving the jack to and from the jacking location.
8
do not direct air from the air hose at yourself or others.
8
do not use the jack if believed to have been subjected to abnormal load or shock. inspect and take appropriate action.
8
2. introduction
ideal for workshop use, this jack doubles up as an axle stand to take the effort out of lifting and holding heavy plant, tractors and commercial
vehicles. multiple lifting and locking positions achieved using extension tube with multi-posision pin support. removable two piece handle aids
easy storage. requires 200psi of air pressure to reach optimum performance.
© Jack sealey limited
instructions for
air jack/stand 10tonne
model no:
Wear protective Wear safety
gloves footwear
.
Original Language Version
ajs10000
Wear protective
clothing
AJs10000 | issue 1 19/07/16