Seaside Stainless Pet Fountain Before we start: Care instructions To keep providing fresh, clean water for your pet, remember these three simple tasks: Refill often. Keep the water level up. The pump is designed to work in at least one inch of water.
Setup instructions Clean the pump before you assemble the fountain: Remove the faceplate. Remove the stator. Remove the impeller. Wash these parts with soap and warm water, then put the pump back together. Rinse all parts of the fountain in cold water except the cord and power adaptor.
Page 5
Install the foam filter and the pump: Insert the pump into the foam filter and set Feed the cord down into the tube and out Insert the silicone cap and fold its top edge both down into the square inside the bowl. between the feet on the bowl’s base.
Page 6
Install the carbon filter and the tower: Rinse the carbon filter with cold water, set it Insert the filter housing into the opening on Set the tower down over the filter housing into the filter housing and close. top of the pump. and press down on the silicone gasket to form a seal.
Use instructions Place the fountain where your pet will use it. Fill the bowl with water, leaving a half inch of space between the water and the rim. Make sure your hands, the cord and the power adaptor are dry, then plug the fountain into an outlet. If your pet is hesitant to use the fountain at first, try leaving the fountain unplugged until your pet is comfortable drinking from it.
Need help?
Do you have a question about the Seaside Stainless Pet Fountain and is the answer not in the manual?
Questions and answers