Sharp WH-T36E Service Manual page 6

The shower installation must be over 1.50 meters from the ground.
2. Removing the body unit cover.
Remove the screw at the bottom of the unit.
Remove the front plate first at the bottom.
Screw
3. Install electric water heater on wall.
Drill 2 holes in the wall with size 6 millimeters, 25 millimeters in depth, distant 178 millimeters
6 mm.
Put fitting in the holes.
Drive screws into the upper fitting and leave screws about 8-10 millimeters in length.
Hang the equipment with the screws and mark the lower points to drill the other 2 holes.
Drill 2 holes and put fittings, then drive all screws firmly.
Over 1.50 meters
25 mm.
6
Fig. 7
Fig. 8
178 mm.
Fig. 9
Fig. 10