Whirlpool WTW6200V Dimensions And Installation Information

®
Automatic Washer
PRODUCT MODEL NUMBERS
WTW6200V
Electrical: A 120-volt, 60-Hz, AC-only, 15- or
20-amp fused electrical supply is required. A time-
delay fuse or circuit breaker and separate circuit
serving only this appliance are recommended.
Water: A water heater set to deliver 120°F (49°C)
water to the washer. Hot and cold faucets located
within 3 ft (90 cm) of the hot and cold water
fill valves, and water pressure of 20 to 100 psi
(138 to 690 kPa).
DRAIN SYSTEM OPTIONS
Standpipe drain system - wall or floor (view A & B)
The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (244 cm) from the bottom of the washer.
A
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
RECESSED AREA AND CLOSET INSTALLATION
For closet installation, with a door, the minimum ventilation openings in the top and
bottom of the door are required (view C). Louvered doors with equivalent air ventilation
openings in the top and bottom are acceptable.
(43.2 cm)
(2.5 cm)
*Required spacing
39"
(99 cm)
B
17"*
1" 27 ⁄ " 1"
1
2
(69.9 cm) (2.5 cm) (2.5 cm)
A
Front view
Laundry tub drain system (view C)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39" (99 cm)
above the floor and no higher than
96" (244 cm) from the bottom of the
washer.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
14"* max.
(35.6 cm)
48 in. *
2
(310 cm )
2
24 in. *
2
(155 cm )
2
1"* 27" 5"*
(68.6 cm) (12.7 cm)
B
Side view Closet door with vents
Floor drain system (view D)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28" (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
28"
(71 cm)
39"
(99 cm)
C
1
3"*
(7.6 cm)
3"*
(7.6 cm)
C
D
2
Ref. W10181465
10-15-08