Arduino Support For Nina-W10; Downloading The Arduino Ide - Ublox NINA-W1 Series System Integration Manual

• RESET to IO19 (CTS)
• IO0 (IO zero) to IO26 (DSR)
The jumpers CTS (J14-8) and DSR (J14-7) should also be removed so that they do not interfere.
☞
It is not possible to use the Hardware Flow control or the DSR signals on the UART while using this
setup.
More information about the esptool is available at -

2.8 Arduino support for NINA-W10

It is possible to use Arduino electronics platform on the NINA-W10. The Arduino platform and open
source community provides the possibility to access a lot of third party hardware such as displays and
sensors.
2.8.1

Downloading the Arduino IDE

Windows, Mac, and Linux environment are supported. The example below uses the Windows
environment. Download the Arduino IDE using the URL - https://www.arduino.cc/en/Main/Software.
Figure 17: Screenshot during installation of the Arduino IDE
Click Install button in the dialog box that pops up during installation as shown in the screenshots
below:
UBX-17005730 - R11
C1 - Public
NINA-W1 series - System integration manual
https://github.com/espressif/esptool
Software Page 24 of 55