Advertisement
Advertisement
Table of Contents
Related Manuals for Vremi VRM050660N
Summary of Contents for Vremi VRM050660N
- Page 1 This Is A Manual. Beverage Cooler Beverage Cooler...
-
Page 2: Before First Use
BEFORE FIRST USE: To prevent any internal damage, it is very important to keep refrigeration units (like this one) upright throughout their journey. Please leave it standing upright and outside the box for 24 HOURS before plugging it in. -
Page 4: Important Safety Instructions
Important Safety Instructions When using electrical appliances, basic safety precautions should always be followed to reduce the risk of explosion, fire, electrical shock, and/or injury to persons. If physical injury or damage is caused by failure to follow these instructions, the warranty does not apply. •... - Page 5 Important Safety Instructions Warnings related to placing items • Do not put flammable, explosive, volatile, or highly corrosive items in the cooler. • Do not place flammable items near the cooler to avoid a fire hazard. • This product is for household refrigeration appliances, mainly used for the storage of beverages.
-
Page 6: Parts List
Parts List Glass Door Shelf Racks (3) Electronic Control Leveling Leg PLACEMENT • Before using the cooler, remove all packaging materials, including bottom cushions, foam pads, and tape inside the cooler. Tear off the protective film on the door and the cooler body. •... -
Page 7: Installation
Operating Instructions INSTALLATION Warning: Excessive Weight Hazard Use two or more people to move and install beverage cooler. Failure to do so can result in back or other injury. • Keep in upright position for 24 hours before initial power up. •... - Page 8 Operating Instructions Top hinge cover Top hinge screws Top hinge Cabinet plug Bottom hinge Door handle plug Bottom hinge screw Leveling legs INTRODUCTION TO THE BEVERAGE COOLER’S FUNCTIONS 1. The maximum capacity is 90 cans (12 oz/335 ml) when placed vertically as shown in Figure A. 2.
- Page 9 Operating Instructions 4. Store beverages in sealed containers only. 5. Operate the beverage cooler by adjusting the temperature control buttons (up and down arrows) to various settings. The adjusting temperature range is between 32°F and 61°F. Press once and the temperature will increase 1 °F. Press once and the temperature will decrease 1 °F.
-
Page 10: Troubleshooting
Troubleshooting Possible Causes & Solutions Problem The door is being opened too often. Or the cooler is too Cooler isn’t cool full of bottles or cans. Reduce the frequency of opening the door. Lower the temperature if needed. The power is out or the cooler isn’t plugged in. Cooler is not refrigerating Unplug and wait for 10 seconds, plug in again. -
Page 11: Cleaning And Maintenance
Cleaning & Maintenance Disconnecting the beverage cooler Unplug the power plug from the socket to disconnect the cooler. Cleaning your beverage cooler Dusting behind the cooler and on the ground will improve the cooling effect and save energy. The interior of the cooler should be cleaned to avoid any odor. Follow the cleaning procedure below: 1. -
Page 12: Warranty Information
Vremi offers a 12-month warranty on all of our products purchased new and unused from Vremi LLC or an authorized reseller, with an original proof of purchase and where a defect has arisen, wholly or substantially, as a result of faulty manufacturing, parts or workmanship during the Warranty Period. - Page 16 Beverage Cooler | 16...
Need help?
Do you have a question about the VRM050660N and is the answer not in the manual?
Questions and answers
My Vremi refrigerator is freezing sodas and water at 37 degrees. Is there a problem?
The Vremi Beverage Cooler (model VRM050660N) does not explicitly mention freezing issues at 37°F. However, if sodas and water are freezing, consider adjusting the temperature to a warmer setting and ensuring the door is properly sealed. If the issue persists, contact Vremi support at support@vremi.com for assistance.
This answer is automatically generated
How to you change from celsius to Fahrenheit?