Troubleshooting; Error Codes - VIRTUFIT TR-50i User Manual

TROUBLE SHOOTING
CODE
Problem: Signal failed between computer and console.
E01
Solution: Check if the wire is undamaged and properly connected, if so replace the circuit
board of the computer or console.
Problem: The motor voltage is not recognized by the controller.
Solution: Check if the positive and negative cable of the motor is properly connected with
E02
the terminal interface of the controller, if that is okay, check if the end tube that is on the
controller and peripheral equipment is damaged. Then consider replacing the console or
motor.
Problem: Speed display is not recognized by the console when the engine is running.
Solution: First check if the engine is running when the machine is started and it shows E03,
then see if the light sensor is good, see if the wire of it is tight or if the transition between
the light sensor and the 4 white pins of the controller are well connected. If all of the above
E03
is correct, see if the area around the 4 white pins on the peripherals are damaged, if not
consider replacing the console and circuit board. If the engine is not running when you
start the machine, and it shows E03, check if the engine is broken and consider replacing
the engine.
Problem: When the motor is running, the voltage exceeds the protection value.
Solution: Check that the motor is in good condition and that there is something stuck
E05
between the conveyor belt which increases the motor resistance. If all of the above is
correct, replace the console.
Problem: Security key signal is not recognized by the computer, showing E07 or "--- --- ---".
E07
Solution: Check if the magnetic parts of the safety key are good plugged in.
16

ERROR CODES

SOLUTION
EN
Virtufit Totally Foldable TR-50i Treadmill