Shark Rotator ZU632 Quick Start Manual

Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
QUICK START GUIDE
WHAT'S INSIDE
A Wand
Motorized Floor Nozzle
B
C
Handle & Hose
ASSEMBLY
A
1
(Click)
B
Insert wand into
motorized floor nozzle.
3
(Click)
D
Place pod onto wand and
slide down to connect.
D Vacuum Pod
Pet Crevice Tool
E
F Pet Multi-Tool
C
2
(Click)
Insert handle into wand.
E F
Connect hose to back of
pod, pressing until it clicks
into place. Store accessories
on the posts on the pod.
Empty dust cup after each use
Pull up on
dust cup
release latch
and lift dust
cup off pod.
Foam filter
Felt filter
HEPA
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and felt
filters and rinse them with water only.
Post-Motor (HEPA):
To access the HEPA filter, pull the Filter Access latch under
4
the filter cover and take off the cover. Remove the HEPA
filter and rinse it with water only.
(Click)
The self-cleaning brushroll automatically removes hair wrap.
If some hair or debris remains after continued use, remove the
cover to access the brushroll.
Using a coin,
turn locks
counterclockwise
to open, then
lift off cover to
access brushroll.
POWERED LIFT-AWAY®
with Self-Cleaning Brushroll
MAINTENANCE
Hold dust cup over
a trash bin and press
the empty-release
latch on the bottom.
Cleaning Filters
TIP:
Wash foam and
Filter
felt filters every
3 months to keep
the suction strong.
Rinse filters with water
only and allow them
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Self-Cleaning Brushroll
Clear Replace cover,
blockages pressing down
from airway. firmly on all sides
before turning
locks clockwise
to close.
Press top
empty-release
latch to access
dust screen and
remove built-up
debris as required.