Changing Your Compactor's Colour - Whirlpool 220-240~volt Instructions For Installation And Use Manual

Changing Your Compactor's Colour
The colour panel on the front of your compactor's
drawer reverses to another colour.
To change the colour of your compactor's front panel,
follow the directions below. All you need is a medium-
sized screwdriver.
1. Slide drawer out.
2. Remove two screws shown.
3. Remove handle.
IMPORTANT: When you are changing front panels,
handle carefully to avoid cuts.
4. Remove the colour panel and reverse. Be careful -
edges may be sharp.
OR
Place extra panel at front with desired colour
showing.
5. Make sure panel(s) are all the way down.
6. Be sure to replace cardboard spacer in its former
position.
7. Replace handle and screws.
8. Slide drawer back in.
OPTION: Match your kitchen's colour scheme by
applying paint, wallpaper, or other material to the
colour panel.
OR
Install a custom-made flat or raised panel in place of
the colour panel(s) and spacer. A panel 5.6 mm thick is
required. Decorative trim or raised panel sections must
be 8 mm from all edges of outer section.
15
- ..-.