Auto Styling Truckman GLS Fitting Instructions Manual page 4

FO RD • R A N G ER MK 3 - 4 / M A Z D A • B T -5 0 M K1
IMPORTANT: Door and tailgate
MUST be closed for step 11.
Tighten the clamps to
11
10Nm Torque using the
17mm wrench (Start with
the middle clamps).
Replace the bolt caps onto
12
the clamps.
E l e c t r i c s
Vehicle wire colours are listed as a guide only. It is imperative that
you check with a multi-meter them before connecting the wiring harness.
In the door sill, expose the wires and locate the brake wire,
3
the central locking wires, the heated rear screen wire, and
the door switch wire
4 Using the scotch locks, fix the loom as shown.
HARDTOP
COLOURS
BLUE
YELLOW
CENTRAL LOCKING (LOCK)
GREY
CENTRAL LOCKING (UNLOCK)
GREEN
BROWN
(Just more than hand tight / 10Nm Torque)
CONNECTED TO
THE VEHICLE'S
BRAKE
HEATED SCREEN
DOOR SWITCH
Vehicle wire colours are listed as a guide.
Please check with a multi-meter before fitting the harness.
EXPECTED VEHICLE
COLOURS
WHITE GREEN
GREEN
RED
BLACK BLUE
RED YELLOW
4
Luxury Tops
Ensure the ignition is off.
1
Remove door sill trim from
the driver's door.
Take the wiring loom from
2
the fitting kit and pass
the '5-wire' leg through
this grommet (under the
driver's seat), into the cab.
NOTES
Checked on a 10 Plate Mk4 Ranger
12V when brake pedal depressed
Door switch needs to be held down, but
these wires flash 12V using the remote
12V when the heated screen is on
Use continuity checker with earth