Speaker And Room; Speaker Configuration; Roomperfect - STEINWAY LYNGDORF Steinway & Sons P100 Owner's Manual

The Speaker and Room menu provides information about the current speaker configuration, allowing
you to select a configuration that is stored on the Model P100, on a laptop, or on a connected
memory stick.

Speaker Configuration

Manage
Add or delete speaker config files.
To add a file, insert a USB stick with the speaker configuration file you have received from your
Steinway Lyngdorf representative, select the file and press Add. The speaker configuration will be
added to the Speaker Configuration list. After adding the speaker configuration, it will be visible as a
menu below Speaker Configuration. Press Left on the remote to select it.
Verify speakers
Press the Verify Speakers button to verify your setup.

RoomPerfect™

Focus position
The focus filter improves the sound quality at a specific listening position. This makes the focus filter the best
solution for optimal sound quality at a single listening position.
Note: It is possible to add multiple focus positions. This must be done after
Edit distance
Be sure to select the unit of measure, then enter the distances to the speakers and woofers.
How to measure distances to speakers and woofers
The best results are obtained by using a laser-equipped measuring device. Before starting, place the
RoomPerfect™ microphone at listening height in the main listening position. For each speaker,
measure the straight-line distance through the air from the tip of the RoomPerfect™ microphone to
the center of the tweeter unit in the loudspeaker in question. Do not measure distances at floor level,
as these measurements will not give acoustically accurate results.
When measuring distances to in-room boundary woofers:
•
If the stack of woofers is taller than the listening position, measure the distance from the listening
position to the back edge of the middle of the stack of woofers.

Speaker and Room

RoomPerfect™ has been set up completely.
13