Table of Contents
Advertisement
Menu / Parameters
Diagnostics / ......Simulation Mode
Simulation Switch
Off
Qm Massflow [unit]
Qm Massflow [%]
Qv Volumeflow [unit]
Qv Volumeflow [%]
Curr.Out 31 / 32
Dig.Out 41 / 42 State
Dig.Out 41 / 42 Pulse
Dig.Out 41 / 42 Freq.
Dig.Out 51 / 52 State
Dig.Out 51 / 52 Pulse
Diagnostics / ...Output Readings
Curr.Out 31 / 32
Dig.Out 41 / 42 Freq.
Dig.Out 41 / 42 State
Dig.Out 51 / 52 State
7.5.9
Menu: Totalizer
Menu / Parameters
Totalizer
...Reset Totalizer
...Preset Totalizer
Totalizer / ...Reset Totalizer
All Totalizer
Massflow Fwd
Massflow Rev
Volumeflow Fwd
Volumeflow Rev
Totalizer / ...Preset Totalizer
Massflow Fwd
Massflow Rev
Volumeflow Fwd
Volumeflow Rev
Change from one to two columns
Description
Used for manual simulation of measured values. After selecting the value to be simulated, a corresponding parameter is
indicated in the "Diagnostics / ......Simulation Mode" menu through which the simulation value can be configured.
The output values correspond to the configured simulated measured value.
The "Configuration" information is indicated in the bottom line on the display.
Only one measured value / output at a time can be selected for simulation purposes.
The simulation function is deactivated after the device has been switched off or is restarted.
Used to display the current values and statuses of the listed inputs and outputs.
Description
Used to select the "...Reset Totalizer" submenu with
Used to select the "...Preset Totalizer" submenu with
Used to reset all meters to zero.
Used to reset individual meters.
Used to enter / edit meter readings (e. g. when a transmitter is replaced).
.
.
7 Operation
67
Advertisement
Table of Contents
