Bill Dispenser; Fujitsu Bill Dispenser; Bill Dispenser Cassette Magnets; How To Set Cartridge Position Magnets - Standard Change-Makers BX Series Installation And Instruction Manual

7.0 BILL DISPENSER

7.1 Fujitsu Bill Dispenser

7.1.1 Bill Dispenser Cassette Magnets

The magnets only indicate the position of the cassette not the denomination. If you want to change the
denomination see setting the Dispenser Value. The cassettes are keyed to match a particular location in
the multi-note bill dispenser. This keying process ensures that the correct cassette is installed in the
corresponding bill dispenser location. If a cassette is installed in the wrong location a flash code "39" will
appear on the bill dispenser control module and the bill dispenser will not enable.
The following procedures explain how to set the keys (Magnets) in the cassettes should it become
necessary at any time. Example: if a replacement cassette is required or if an additional dispense cartridge
is added to upgrade from a dual cassette dispenser to make it a triple cassette dispenser.

7.1.2 How To Set Cartridge Position Magnets

Use the procedure below to set the "cartridge position" magnets. These magnets are used to make sure the
cassettes are not inadvertently placed into the wrong location in the dispenser. A flash code "39" on the
bill dispenser controller module (silver box w/red reset button – see picture on following page) indicates
that the wrong cassette (or cassette w/wrong magnet pattern) was installed in the dispenser.
Push
Button
To Open
Open Position
IMPORTANT NOTE: The magnets are polar sensitive. The face of magnet is painted white. Be sure
to install the magnet face in the same direction as it was when you moved the magnet to a new spot.
41