Vrrpv3; Router - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Configuring with Web Based Management
4.8 "Layer 3" menu
4.8.4

VRRPv3

4.8.4.1

Router

Introduction
Using the "Create" button, you can create new virtual routers. A maximum of 2 virtual routers
can be configured. You can configure other parameters on the "Configuration" tab.
Note
● You can use VRRPv3 on VLAN interfaces.
Requirement
For the incoming packets to be forwarded to the device, enable the predefined IPv4 rule
"VRRP".
Description
The page contains the following:
● VRRPv3
Enable or disable routing using VRRPv3.
● Reply to pings on virtual interfaces
When enabled, the virtual IPv4 addresses also reply to the ping.
● VRID-Tracking
Enable or disable VRID tracking.
When enabled, all VRRP instances are monitored. If the status of a VRRP instance changes
to "Initialize", the priority of all VRRP instances is reduced to the value "1".
If the status of a VRRP instance changes, the original priority of all VRRP instances is
restored.
244
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08