Charging Safety
•
Do not probe terminals with conductive objects.
•
Only charge a PowaKaddy battery using the supplied PowaKaddy charger. The charger and battery pack are
specifically designed to work together.
•
Only charge on a hard, flat surface.
•
The charger will get warm, do not cover the charger.
•
Do not expose the charger to rain or snow.
•
Do not use a charger if the plug, leads, contacts or casing is damaged.
•
Remove the plug with care Do not pull on the cord.
•
Avoid using an extension cable.
Lithium Battery Storage
Batteries are to be stored in a cool and dry place away from direct sunlight and excessive heat or cold; ideally
store at room temperature. Charge your battery fully before storing. Charge once every three months
thereafter.
Battery Transportation
Ensure the battery is turned off when transporting the trolley to avoid activating the trolley and discharging
the battery. Check with your airline before attempting to ship your battery by air.
Lithium Battery Disposal
At the end of its useful life, please discard the battery with due care for the environment.
1. If possible, run down the battery completely and remove from the trolley.
2. Take the battery to your local recycling centre.
Maintenance
10
Your PowaKaddy trolley is easy to maintain.
•
Never jet wash or immerse in water. Clean the trolley using a sponge and warm water to remove mud, grass
and other debris.
•
Occasionally remove the wheels and apply grease to the axles and moving parts.
Your serial number can be found in the cavity of the rear joint, please make a note for future reference.
Should you experience a problem with your PowaKaddy product, please visit www.powakaddy.com/support
Need help?
Do you have a question about the FX3 and is the answer not in the manual?
Questions and answers
The grey button is stuck and I can’t unfold the trolley
The provided context does not contain specific instructions for fixing a stuck grey button on a Powakaddy FX3 trolley. However, you can try the following general troubleshooting steps:
1. Ensure there is no dirt or debris blocking the button.
2. Press the button firmly while slightly adjusting the handle to relieve any tension.
3. Apply a small amount of lubricant if the button feels stiff.
4. Check if any visible obstructions are preventing movement.
5. If the issue persists, consult the manual or contact Powakaddy support.
If further details are needed, refer to the official manual or support service.
This answer is automatically generated