What Is Pv Doing To The Emulator; Troubleshooting - HP 64782 Series Manual

What is pv doing to the Emulator?

The performance verification procedures (PV) provide a thorough check of the
functionality of all of the products installed in the HP 64700 Card Cage. The PV
procedures change the emulator configuration, content of the processor internal
registers, and the processor internal memory (including TPU internal memory).
After PV, you will need to reload the emulation configuration and program. The
following is an example Test Suite for an HP 64700 Card Cage containing an
HP 64782 Emulator. To see the exact Test Suite for the HP 64782 Emulator and
associated modules in your HP 64700 Card Cage, enter the command: pv -l.
Tests available in Emulator Subsystem:
test # 1 (ABG Type Map)
test # 2 (ABG 68k RAM -Host Side)
test # 3 (ABG 68k RAM - CPU Side)
test # 4 (Host Side SIMM Data)
test # 5 (Host Side SIMM Address)
test # 6 (In-Circuit Verification)
test # 7 (Emulator Reset)
test # 8 (Background Monitor)
test # 9 (Processor Address Lines)
test #10 (Target Reset and Halt)
test #11 (Target Data)
test #12 (Target Address)
test #13 (Chip Selects [5:0] and CSBOOT)
test #14 (Sim Ports E and F)
test #15 (Target Run and BERR)
test #16 (Demo RAM Cell Test)
test #17 (SIMM Cell Test)
test #18 (LED Test)
test #19 (Tri-State Control)
test #20 (Guarded Break Test)
test #21 (ROM Break Test)
test #22 (Step Break Test)
test #23 (Software Break Test)
test #24 (Analysis Trace Test)
test #25 (Analysis Break Test)
test #26 (CMB Test)
test #27 (QSM Port)
test #28 (TPU Port)
test #29 (QADC Port)
test #30 (CTM4 Port)

Troubleshooting

The test results for all of these modules are indicated by a simple PASS/FAIL
message. The PASS message gives a high level of confidence that all major
functions and signals are operating because it includes a loopback test that includes
read and write tests to the demo board. The demo board also stimulates inputs to
the emulator.
A FAIL message on the other hand indicates that one or more of the tested
functions is NOT working. In this event, an HP field representative can either swap
Chapter 6: Solving Problems
To verify the performance of the emulator
105