Greencut JET-3800SX Instruction Manual page 76

76
HOSES AND FITTINGS
TURBO-HEAD ASSEMBLY
If the "turbo head" and turbo-head is not assembled, 1) wrap the threaded part of the turbo-head adaptor fitting
with plumbers Teflon tape (not supplied), then 2) screw the adaptor into the turbo-head, then 3) use an Allen key
through the adaptor to tighten it firmly to the turbo-head.
"QUICK-CONNECT" TYPE CONNECTORS
1. Ensure the connectors are clean.
2. Pull back on the knurled ring until the ball bearings are visible and hold it in this position, then insert the male
connector into the female. When the parts are fully connected, release the knurled ring.
NOZZLES
The machine may come supplied with a variety of nozzles. Each nozzle is colour-coded for identification and produces
a different spray pattern for different tasks. Nozzle colours may vary – check each before use.
• Red – 0° spread. Highest possible pressure for difficult cleaning tasks including stained concrete and paint
removal. Not recommended for soft materials, decking or automotive.
• Yellow – 15° spread. Very high pressure for heavy cleaning tasks including, concrete, decking and paint removal.
Not recommended for soft materials or automotive.
• Green – 25° spread. High pressure for general cleaning tasks including automotive.
• White – 40° spread. Moderate pressure for general cleaning larger surfaces.
• Black – 65° spread. Low pressure for general cleaning larger surfaces and when using detergent.
1
3
2