German pool EFB-326H User Manual page 6

Operating Instructions
The device can be switched on and off by pressing the "On / Off" Button
On/Off
Press "Sleep Mode" Button on the Remote Control.
The display shows "LL" and the fan speed becomes lowest.
Press again to exit the "Sleep Mode".
Sleep Mode
(You can also exit the current mode by pressing the Wind Strength + button.)
Press "High Cool" Button on the Remote Control.
The display shows "HH" and the fan speed become highest.
Press again to exit the Turbo Mode.
High Cool
(You can also exit the current mode by pressing the Wind Strength + button.)
Press the "Oscillating" Button to turn on the Oscillation Function.
This fan can swing left and right at 80o. Press this button again to stop oscillating.
Oscillating
Press "Sound" Button to turn on/off the sound of fan. The sounds refer to the tone of
turning on and off the fan using the Remote Control.
Sound
During Cool Mode, the LED display is on with blue light.
Press this button to activate the Cool Mode.
Cool Mode
Note: The default Start Mode is the Cool Mode.
Press the "+" Button on the left side of the Remote Control
to increase the volume of air; press the "-" button on the left side of the Remote
Increase /
Control to decrease the volume of air.
Decrease
Cool Mode can be used for 9-level settings, Warm Mode can be set for 4 levels.
Air Volume
Press this "Warm Mode" Button to activate the Warm Mode.
The display number in Warm Mode is orange.
Warm Mode
Note: During Warm Mode, both High Cool and Sleep Mode are not available.
In Warm Mode, press the "+ -" Button on the right side
Raise /
of the Remote Control to set the Temperature (1-30°C).
Reduce
Note: this button does not work during Cool Mode.
Temperature
Press the "Timer" Button on the Remote Control to set 1 to 8 hours of timing.
Timer
P.10
Operating Instructions
Remote Control
The Remote Control should be pointed at the Remote Control Signal Receiver on the display to
maximize the remote control signal. Effective distance: 5M.
Signal Receiver
Caution:
Remote Control error sometimes occurs due to the overlap of the channel frequencies. For example:
1. This product may react to the remote control of another appliances nearby; or
2. When using the remote control of this product, other electrical appliances may react.
In order to avoid misuse, please operate this Remote Control away from any other appliances.
After switching the product to a standby mode, use the main switch in
the product to power off, since using the Remote Control to turn it off
would not cut off electricity completely. When the product is not in use
for a long time, please unplug the power cord.
P.11