Page 1
Manual - English 1. Introduction Thank you for choosing a Locinox gatecloser! Please read the following instructions carefully before mounting the Mammoth & Rhino to your swing gate. Enclosed you will find all relevant user information concerning the Mammoth. 2. Package Contents...
Page 2
5. Choose the turning-direction of your gate Before preparing your profiles, decide if you have a left- or right hand door. The fixing of Mammoth and Rhino are different for each situation! 6. Profile preparation Left hand door Right hand door www.GateHardwareKing.com | (800) 878-7829...
Page 3
Left hand door Right hand door Stick the templates to gate and post. Make sure that front and side are stuck correctly. FRONT FRONT SIDE SIDE Align both templates using a spirit level www.GateHardwareKing.com | (800) 878-7829...
Page 4
Center and drill the holes marked on the templates. Tighten the Quick-Fix. Always start with the L-side of the Mammoth and Rhino. Tighten the Quick-Fix. After fixing the L-side you can tighten the other wing of the Mammoth and Rhino. www.GateHardwareKing.com | (800) 878-7829...
Page 5
7. Speed and final snap adjustment 8. Force adjustment Out of the box the product is set to maximum closing-force. We advise not to adjust closing-force unless in specific situations where a lower opening force is required. Start with removing the covercap. Insert Allen key and push down firmly to disengage. Turn clockwise to decrease the spring-force. Spring can be clutched every 90°.
Page 6
8. Finalysing the installation Before finishing the product with covercaps & plugs, make sure you well tested the final snap, speed and force adjustments. www.GateHardwareKing.com | (800) 878-7829...
Need help?
Do you have a question about the MAMMOTH and is the answer not in the manual?
Questions and answers