Vxl-3S Setup Programming; Vxl-3S Operation; To Turn Low-Voltage Detection On (Lipo Setting) - Traxxas Velineon 3350 Owner's Manual

VxL-3s Setup and Operation

To turn Low-Voltage Detection on (LiPo setting):

1. Make sure the LED on the VXL-3s is
on and red.
2. Press and hold the EZ-Set button
for ten seconds. The LED will turn
off and then light green. Also,
a "rising" musical tone will be
emitted from the motor.
3. Low-Voltage Detection is now ON.

VxL-3s Setup Programming

(Calibrating your ESC and transmitter)
Read through all of the programming steps before you
begin. If you get lost during programming or receive
unexpected results, simply unplug the battery, wait a few
seconds, plug the battery back in, and start over.
1. Connect a fully charged battery
pack to the VXL-3s.
2. Turn on the transmitter (with the
throttle at neutral).
3. Press and hold the EZ-Set
button (A). The LED will first
turn green and then red.
Release the EZ-Set button.
18 • VELINEON POWER SYSTEM
1
2
A
Green then Red
B
Once Red
4. When the LED blinks RED
ONCE. Pull the throttle trigger
to the full throttle position and
hold it there (B).
5. When the LED blinks RED
TWICE. Push the throttle trigger to
the full reverse and hold it there (C).
6. When the LED blinks GREEN ONCE,
programming is complete. The LED will then shine green
or red (depending on low-voltage detection setting)
indicating the VXL-3s is on and at neutral (D).

VxL-3s Operation

To operate the speed control and test programming,
place the vehicle on a stable block or stand so that all
of the driven wheels are off the ground. Disconnect
motor wires "A" and "C", this will assure the motor
does not drive the wheels during testing. Do not test
programming without disconnecting the motor wires.
Note that in the following steps 1-7, Low Voltage Detection
is turn ON (factory default) and the LED shines green. If Low
Voltage Detection is OFF, the LED will shine red instead of
green in the following steps 1-7.
C
Twice Red
D
Once Green