Lemo 0F Series Manual

If you have any
questions or
require customer
assistance, please
contact us directly
at (800) 444-5366.
©2003 LEMO USA, Inc. 9/03
3
FGN
±0.5
14
1
±0.2
3
2
Crimp
3
Tie wrap
Heat
P.O. Box 2408, Rohnert Park, CA 94927-2408
(800) 444-5366 • (707) 578-8811 • fax: (707) 578-0869
www.LEMOusa.com • e-mail: info@lemousa.com
2
1.

Cable preparation

First, place the heatshrink boot
individual conductors according to the indicated dimensions and
flare the shield braid.
2.

Cable termination

2.1 Fix the appropriate positioner in the crimping tool and set the
selector to the number corresponding to the conductor AWG as
indicated on the positioner label. Fit conductor into contact
make sure it is visible through the inspection hole in the crimp
barrel. Open crimping tool then push contact fully into positioner
and complete one crimping cycle. Remove from crimping tool and
check that conductor is secure in contact and shows in inspection
hole.
2.2 Slide the assembly into the connector shell
Arrange the contacts according to the marking, then push them
into the insulator, make sure the contacts are in place by gently
pulling on the cable. Fill up the back of the cabling chamber with
compound RTV silicone.
2.3 For shielded cables, put the shield braid over the rear of the con-
nector. Cut off possible surplus. Use a band-it tie wrap to fix the
braid in place (See below for recommended tie-wrap and banding
tool).
Banding tool
Tie wrap
2.4 Put the heatshrink boot in place and heat gently until it retracts.
LEMO USA, Inc.
635 Park Court, Rohnert Park, CA 94928
1
on the cable. Strip the
.
Part number
GLEN-AIR ® TIE-DEX ®
600-061 A30199
600-057 A31189
F
FF
and
AXON ®
ACDBS100
AXCL0Z