Kenwood NX-5000 Series Function Reference page 111

2 COMMUNICATIONS IN AN EMERGENCY
2.1 Placing the Transceiver in Emergency Mode
If Emergency Mode is activated by pressing the Emergency key or by the Lone Worker function, Emergency Mode will be
exited when the Emergency key is pressed longer than the time configured in Hold Delay or when the transceiver is turned
off.
If Emergency Mode is activated by the Activity Detection function, Emergency Mode will be exited when the transceiver is
turned off.
However, if Suspended Power-off is enabled, the transceiver will not be turned off and remains in Emergency Mode even
if the transceiver is operated to be turned off while in Emergency Mode. (Refer to
Note
If the transceiver enters Emergency Mode during a scan, Emergency behaves according to the configuration in
0
Emergency Profile for the selected channel.
The PTT switch can be used even if the transceiver is in Emergency Mode. The transceiver reverts to automatic receive
0
mode when the transceiver completes transmitting by releasing the PTT switch.
In Emergency Mode, the microphone sensitivity is determined by the configuration in Emergency Microphone Sense.
0
(Refer to Emergency Microphone
The transceiver does not decode the Stun Code and Optional Signaling in Emergency Mode.
0
If the transceiver receives the status configured for Emergency Termination Status in Emergency Mode, the transceiver
0
exits Emergency Mode.
While the transceiver is under the following conditions, the transceiver does not enter Emergency Mode:
0
In the Stun state
0
If the transceiver is in Transceiver Password entry state
0
When "Selected" is configured in Emergency Channel Type and the selected channel is an error channel
0
The Radio Check command can also be received when the transceiver is in Emergency Mode.
0
The following functions are disabled while the transceiver is in Emergency Mode:
0
Lone Worker key
0
Lone Worker Channel (if "Preset" is configured in Lone Worker Type)
0
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Emergency Termination Status (
Conventional > Emergency > Emergency ID (DMR Conventional))
DMR FUNC (K, F)/Ver 2.20
Sense.)
Transceiver Settings > Personal > Personal Features > DMR
Suspended
Transceiver Settings > Key Assignment)
CONTENTS
Power-off.)
94
INDEX