Need Help - Epson BrightLink 696Ui Manual

Calibration
Calibration coordinates the position of the pen or your
finger with the location of your cursor. If the pen or
finger position and cursor location don't match, you can
perform auto calibration, or you can calibrate manually for
even greater accuracy.
Note: You must perform pen calibration before calibrating
finger touch.
Pen Calibration
1
To start pen calibration, press the User button on the
remote control, or press the Home button and select
Auto Calibration.
2
When you see the Auto Calibration screen, do one of
the following:
• Press to run auto calibration, then wait until
calibration is complete.
• Select No, then press
below to calibrate manually.
3
Select Manual Calibration, then press
4
When you see the Manual Calibration screen, press
to select Yes.
5
Touch the center of the circles on the screen with
your pen to perform manual calibration.
Finger Touch Calibration
Note: If you are unable to perform finger touch
calibration, make sure that the installer properly installed
the Touch Unit and performed the angle adjustment.
1
To start finger touch calibration, press the User
button on the remote control, or press the Home
button and select Auto Calibration.
2
When you see the Auto Calibration screen, select
No, then press
3
Select Touch Unit Setup, then press
4
Select Touch Calibration, then press
and follow the steps
.
and follow the steps below.
.
.
5
When you see the Touch Calibration screen, press
to select Yes.
A green circle appears in the upper left corner of
your projected image.
6
Touch and hold the center of the circle with your
finger until the circle disappears and another one
appears.
Note: Make sure you touch the center of each circle;
otherwise the calibration may not be accurate.
7
Continue until all of the circles disappear.
For more detailed instructions, see the online BrightLink
User's Guide.

Need Help?

Telephone Support
The Epson PrivateLine
® ®
All you have to do is call (800) 637-7661. This service is
available for the duration of your warranty period.
You may also speak with a projector support specialist by
dialing (562) 276-4394 (U.S) or (905) 709-3839 (Canada).
Support hours are 6 to 8
am
through Friday, and 7
am
Days and hours of support are subject to change without
notice. Toll or long distance charges may apply.
Online Support
To access the online User's Guide, get FAQs, and more,
visit www.epson/com/brightlinkdownloads (U.S.) or
www.epson.ca/brightlinkdownloads (Canada) and
select your product.
EPSON is a registered trademark and EPSON Exceed Your Vision is a registered
logomark of Seiko Epson Corporation. BrightLink and PrivateLine are registered
trademarks of Epson America, Inc.
Mac is a trademark of Apple Inc., registered in the U.S. and other countries.
General Notice: Other product names used herein are for identification purposes
only and may be trademarks of their respective owners. Epson disclaims any and
all rights in those marks.
This information is subject to change without notice.
© 2016 Epson America, Inc., 9/16
Printed in XXXXXX
service is for you!
, Pacific Time, Monday
pm
to 4 , Pacific Time, Saturday.
pm
CPD-52474