Troubleshooting - PlaSmart PlasmaCar Assembly

Troubleshooting

The rear wheels may detach from their housing if the PlasmaCar is subjected
to overloading or impact. Fit the wheel into its housing so that the flat sides
of the white clips contact the wheel housing. Snap the wheel back into place.
If the steering wheel becomes loose or fails to propel the PlasmaCar, the
steering wheel nut may not have been tightened enough during assembly.
Remove the cap from the steering wheel with a slot screwdriver and loosen
the nut with the hex key. Repeat steps 7 and 8, securing the nut as tightly as
possible.
14