Tap Tempo - Red Panda CONTEXT 2 Owner's Manual

You can set independent note divisions for delay time, reverb pre-delay, and tremolo rate. The tap divi-
sions are stored in presets, and delay note division set via the mode knob is remembered when power is
removed.
The CTRL port supports external tap tempo switches that use a normally open contact, including
multi-output tap controllers. Some remote switch modes also provide a tap tempo switch. Tap the
switch at quarter note intervals to set the delay time using tap tempo. The LED will blink yellow to indi-
cate the current tempo. To cancel tap tempo, quickly double tap the left (TAP) footswitch.
Adjusting a knob will disable tap tempo for that parameter. To re-enable tap tempo, set the interval
again or reload the preset.
If you need to synchronize multiple tap-tempo pedals, you can use a multiple output tap controller, USB,
or 1/4" TRS MIDI.
To set delay tap divisions, hold the SHIFT button and rotate the mode knob. More note divisions are
available via MIDI or using our web editor.
By default, the delay time is set for quarter notes and tap divisions are off for other parameters.
Delay note divisions (MODE knob)
Mode
ROOM
HALL
CATH
GATE
REV
PLATE
SPRING
GRAIN
18
Note Division
Off
Half note
Dotted quarter note
Quarter note
Quarter note triplet
Dotted eight note
Eighth note
Eighth note triplet

Tap Tempo