Power Up/Down; Standard Operation - Shur-Co SMART3 Operating Instructions Manual

P/N 1126870 Rev. B

POWER UP/DOWN

Transmitter (remote) will power up when lid is opened. Remote
will power down when lid is closed or left open three minutes after
last button is pushed.
flashing
light
indicates
active
channel

STANDARD OPERATION

After power-up, first channel will be immediately active and
indicator light will be flashing. Open/On and Close/Off buttons
are operational for indicated active channel. While either Open
or Close button is pressed, indicator light for active channel will
flash faster, indicating command is being transmitted on active
channel. Select button will cycle between enabled channels.
If light does not flash more quickly when a command button is held,
then remote has not connected to receiver. Receiver may not be
nearby, may not be powered up or may not be paired to receiver.
Each channel on remote can be set to operate in either Momentary
Mode or Express Mode.
Wireless Remote Programming & Operating Instructions
NOTE: Remote ships from factory with first channel (TARP)
configured to EXPRESS MODE. Other four channels are
configured to MANUAL MODE.
NOTE: See CHANNEL CONFIGURATION section for
instructions on how to set operating mode for each channel.
NOTE: Even if remote channel is configured to EXPRESS
MODE, system will not operate in EXPRESS MODE unless
encoder wires between motor and control box are connected.
NOTE: Some Shur-Co
EXPRESS MODE. If motor does not have encoder wire or
other feedback, system will operate in MOMENTARY MODE
only.
NOTE: If your system is not compatible with EXPRESS
MODE, disable EXPRESS MODE for that channel to avoid
confusion.
Momentary Mode: While remote channel is in Momentary Mode,
Open or Close button must be held down to operate system.
Indicator light labeled Express Mode will be off when remote is
express
mode
in Momentary Mode.
indicator
light
If remote channel is in Momentary Mode, you may still force
system to open or close automatically one time by pressing Open
or Close, while pressing Select button. System will continue to
operate until fully open or closed. System can be stopped at
any time by pressing any button on remote or closing remote lid.
Indicator light labeled EXPRESS MODE will be lit while system
is operating in that mode.
Express Mode: While remote channel is in Express Mode, Open
or Close button can be pressed and released. System will con-
tinue to operate until fully open or closed. System can be stopped
at any time by pressing any button on remote or closing remote lid.
Indicator light labeled Express Mode will be on when remote is
in that mode.
NOTE: 4500 HD Tarp systems operate in EXPRESS MODE
when commanded to operate from buttons on trailer-mounted
control box. Closing remote lid or pressing SELECT button
will not stop system in this case. Pressing OPEN or CLOSE
button on remote will stop system if in range.
products are not compatible with
®
2