Using Smartrf Flash Programmer Software - Texas Instruments CC2541 User Manual

Using SmartRF Flash Programmer Software

NOTE: The status indicator LED on the CC debugger should turn on. If the LED is red, no CC2540
device is detected. If the LED is green, a CC2540 device has been detected.
If the USB dongle is connected and the LED is red, pressing reset on the CC debugger. This
resets the debugger and re-checks for a CC2540 device. If the LED still does not turn green,
re-check that all cables are securely connected.
When the CC debugger status LED is showing green, you can use IAR to debug or to read or write a hex
file to and from the USB dongle.
6.3 Using SmartRF Flash Programmer Software
Use the instructions with the latest version of SmartRF Flash Programmer (version 1.12.6), available at
the following URL: http://www.ti.com/tool/flash-programmer.
To start the application, do the following:
1. Navigate to Start.
2. Navigate to All Programs.
3. Navigate to Texas Instruments.
4. Navigate to SmartRF Flash Programmer.
5. Navigate to SmartRF Flash Programmer.
Figure 6-3 shows the program start-up screen.
22
Programming and Debugging the CC2541 Advanced Remote
Copyright © 2013–2015, Texas Instruments Incorporated
SWRU343A – April 2013 – Revised June 2015
Submit Documentation Feedback
www.ti.com