Maintenance; Installation; Mount The Receiver; Install Receiver And Output Wiring - HETRONIC BMS-1 Operator's Manual

4. Refer to machine's operator manual for further
instructions.
GL-2
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.

MOUNT THE RECEIVER

Install Receiver and Output Wiring

Select a position for the receiver that provides
protection from violent impact from debris or thrown
materials and is easily accessible. The receiver
housing is rated IP65 and can withstand direct water jet
spray and is protected against penetration of dust.
Therefore, weather and elements should not be the
primary concern when installing the receiver.
Four mounting holes are required when installing the
receiver unit. The drill pattern and recommended
hardware are shown in the following illustration.
4.57"
(116 mm)
Emergency Stop
Pushbutton
GL2_0020

INSTALLATION

DRILL PATTERN
Drill 4 holes 9/32" (7mm).
Use 1/4" or 6mm bolts.
9.13"
(232 mm)
BMS_0030
NVL_0010

MAINTENANCE

Always shut off power to the machine and the radio
remote control before any assembly, maintenance or
repair.
If the receiver includes an attached antenna, mount the
receiver so that the antenna points straight up. The
area around the antenna should be free of
obstructions, especially metal.
Antenna must be
vertical (pointing up).
5
Nova-L
Emergency Stop
Pushbuttons
Area must be
free of
obstructions
8.29"
(210.5 mm)
9.72"
(246.8 mm)
NVL_0020
BMS_0040