Harness Connections - Stinger HEIGH10 Installation Manual

Harness Connections

Parts Needed:
From the HEIGH10 Box:
8 Pin Display Power Harness

LVDS Display Video Cable (Blue USB type)

From the RP4-FD11 Box:
RP4-FD11 Control Module


CR6 Antenna Adapter

3 Harnesses from Page 7
Using a small flat blade screwdriver or similar, set the dial on the side
of the RP4-FD11 module to Number 4. Remove the sticker covering
the 16 Pin plug on the end.
Referring to FIG B at right, make the following connections:
1. Plug in the 16 Pin Power/Speaker Harness
2. Plug in the 10 Pin Multi Camera Harness
3. Plug in the LVDS Display Video Cable (Blue USB type)
4. Plug in the 8 Pin Display Power Harness
5. Plug the CR06 Antenna Adapter into the antenna connector
6. Plug the 16 Pin Interface Harness into the RP4-FD11 module
If the vehicle is equipped with Steering Wheel Controls
7. Plug in the 6 Pin SWI/IR Harness
8. Plug in the 3.5mm headphone jack into the female 3.5mm marked SWI
9. Plug the 4 Pin SWC Harness into the RP4-FD11 module
NOTE! These are the connections for the basic installation, there are
additional harnesses included with the HEIGH10 kit (Amplifier, SiriusXM,
Camera, Microphone, Aux). If not being used, it is recommended to save
these as they might be needed in the future.
14