Eh-800 Network Settings - OUMAN EH-800 Series User Manual

EH-800 network settings

Device settings -> Network settings
The EH-800 controller can be connected to the internet or a shiel-
ded intranet and can be controlled using a computer's browser.
When connecting the device to the internet, Ouman recommends
using Ouman internet and information security solution 3G STD
or 3G PRO (an installation and configuration guide is included with
the product). The user can then control, adjust and monitor buil-
ding technology regardless of time and place. Internet Explorer and
Mozilla Firefox are supported browsers.
If the controller is connected to a network, it has to be given an IP-
address, subnet mask and default gateway (internet use) as well
as a user name and password. Instructions for entering needed in-
formation into EH-800 are in the next section. EH-800B cannot be
connected to a network.
Instructions for connecting the EH-800 device to a intranet:
1. After the PC has been started up select: "Start" -> "Run"
2. Enter "cmd" in the command prompt and select "OK".
3. Enter "ipconfig" in the command prompt and press "Enter".
EH-800 can be connected to an intranet if the address begins with
the following numbers:
* 10.x.x.x
(esim. 10.2.40.50)
* 192.168.x.x
(esim. 192.168.0.2)
* 172.16.x.x – 172.31.x.x
(esim. 172.18.0.5 )
If the IP-address begins with different numbers, it usually means the
following:
* The service does not have a firewall device, meaning that the
service is an unshielded direct connection to a public network.
EH-800 cannot be directly connected to a facility's intranet with
these settings administration products 3G STD and 3G PRO.
4. Write down the following information:
- IP-address, for example, 10.2.74.146
- Subnet mask, for example, 255.255.255.0
- Gateway, for example, 10.2.74.1
5. Close command prompt, write exit.
6. In the EH-800 controller go to device settings -> Network
settings menu
7. In item 4 write the IP-address on the "IP-address" row of the
configure window. Add ten to the last number series row. (e.g.,
10.2.74.146 + 10 = 10.2.74.156) Enter the first number and con-
firm. Then give the second, third and fourth number (the fourth
number should be between 1...253. The set number cannot be
reserved for another device).
Device settings...Network settings
IP-address
Subnet mask
Default gateway
Port 80 >
Web username
Web password password >
IP-adress
Give number 1:
0.0.0.0
Kellonajan asettaminen
min: 0 max: 255
8. Enter the same subnet mask which you have written for your-
self in item 4.
9. Enter the same gateway that you received into the controller.
10. The port address usually does not have to be changed. If port
address 80 is reserved for some other device, change the port
address (e.g., 81) and write the port number after the IP-address
in the browser (e.g., http://10.2.40.50.81).
40
Note!
0.0.0.0 >
7
0.0.0.0 >
8
Restart the cont-
0.0.0.0 >
9
roller after chan-
10
username > ging network
11
settings for the
changes to come
into effect.