Advertisement
Note: File away sharp edges and burrs, and
apply Toro touchup paint to any areas where bare
metal has been exposed.
5. Install the new hanger brackets on the deck brackets
as shown in Figure 3 and Figure 4.
1
4
3
Rear right-hand side shown from the left side
1. Hanger bracket
2. Deck bracket
5
4
3
2
1
Rear left-hand side shown from the rear
1. Nut (existing)
2. Eccentric
3. Carriage bolt (existing)
6. Install a deck support bracket on each hanger bracket
with a shoulder bolt and a locknut (Figure 5).
4
G018236
Figure 3
3. Carriage bolt (existing)
4. Nut (existing)
G018237
Figure 4
4. Deck bracket
5. Hanger bracket
Note: Install the shoulder bolt through the upper
hole in each hanger bracket (Figure 5).
2
3
2
3
1. Locknut
2. Carriage bolt (existing)
3. Clevis pin
4. Deck support bracket
7. After hanging the hanger brackets on the rear lift rod,
install the open end of each deck support bracket to
the hanger bracket with a clevis pin, a flat washer,
and a cotter pin (Figure 5 and Figure 6).
3
1
2
1
Figure 5
Rear right-hand side shown
5. Shoulder bolt
6. Flat washer
7. Cotter pin
4 5
6
7
G018238
Advertisement
