gefran ADV200 WA Functions Description And Parameters List page 24

Example 2: Speed ref 1 = + 400 rpm
Menu PAR Description
5.21 650 Speed ref 1 src
5.22 652 Speed ref 2 src
Selection of the origin (source) of the drive speed reference signals. The values that can be used as speed
references can be selected from those listed in the "L_MLTREF" selection list.
When assigning the reference via terminals, signals with ±10V, 0 ...10V, 0... 20 mA and 4 ... 20 mA can be
used.
Menu PAR Description
5.23 654 Speed ref invert src
Selection of the origin (source) of the signal that inverts the speed reference output from the regulator. The ter-
minal that can be used for this function can be selected from among those listed in the "L_DIGSEL2" selection
list.
Menu PAR Description
5.24 660 Speed ref 1 mon
5.25 662 Speed ref 2 mon
The value of the relative speed reference is displayed.
Menu PAR Description
5.26 670 Speed ref top lim
Setting of the upper speed reference limit. If the speed reference exceeds the limits, the motor speed remains
at the set limit value in any case. Speed limits cannot be more than 200% of the value set in the Full scale
speed parameter (REFERENCES menu par. 680).
Menu PAR Description
5.27 672 Speed ref bottom lim
Setting of the lower speed reference limit. If the speed reference exceeds the limits, the motor speed remains
at the set limit value in any case. Speed limits cannot be more than 200% of the value set in the Full scale
speed parameter (REFERENCES menu par. 680).
Menu PAR Description
5.28 680 Full scale speed
Setting of the reference value for all speed percentage data (References, Speed adaptives ...) corresponding
to 100 % of the actual speed. This parameter can only be changed with the inverter blocked (Enable drive =
Disabled). The recommended setting for the value of this parameter is the motor rated speed. If altered, the
self-tuning procedure should be repeated.
Full scale speed does not define the maximum possible speed. In any case, the maximum
speed percentage value is ± 200 % of the Full scale speed value.
,
24
Speed ref = 400 rpm – 600 rpm = - 200 rpm
UM Type
LINK
LINK
UM Type
LINK
UM Type
FF INT16
FF INT16
UM Type
FF INT32
UM Type
FF INT32
UM Type
rpm INT16
Speed ref 2 = - 600 rpm
FB BIT Def
16/32 640
16/32 642
FB BIT Def
16 6000
FB BIT Def
0
0
FB BIT Def
CALCI
FB BIT Def
CALCI
FB BIT Def
CALCI
ADV200 WA • Functions description and parameters list
Min Max
0 16384
0 16384
Min Max
0 16384
Min Max
0 0
0 0
Min Max
0 CALCI
Min Max
CALCI 0
Min Max
50 32000
Acc Mod
ERW VS
ERW VS
Acc Mod
ERWZ VS
Acc Mod
ER VS
ER VS
Acc Mod
ERWZ VS
Acc Mod
ERWZ VS
Acc Mod
RWZ VS