Siemens Sitraffic Sensus Unit C3077 Installation And Safety Instructions page 14

ENGLISH
8 Mounting and installing the Sitraffic Sensus Unit
Mounting the suction cups to the holder
Attach the provided suction cups to the holder as shown in the related figure.
Connecting the power cable to the Sitraffic Sensus Unit
1. Remove the connector panel cover of the device.
2. Plug the provided power supply cable into the power socket and make sure that the
plug's snap catch has engaged.
3. Make sure that the rubber tube of the provided power supply cable is located at the
right position.
4. Close the device again with the connector panel cover.
Danger of fire and malfunction! Always protect the power supply cable against mechanical
forces and other negative factors (e.g. extensive heat, aggressive chemicals) which could
lead to destruction of isolation and short circuits. Replace damaged cables immediately!
Determine the Sitraffic Sensus Unit mounting location
Determine the mounting location on the inside of the windscreen such that:
• the driver's field of vision is not impaired while driving,
• the chosen position must not be near moving parts e.g. air bag covers of the vehicle,
• the Sitraffic Sensus Unit is visible from outside and is not hidden by other elements such as
windscreen wipers when off,
• the Sitraffic Sensus Unit does not constrain the function of the defroster vents,
• in the case of metalized windscreen use non-metalized area,
• local laws and regulations as well as recommendations of the vehicle manufacturer are
complied with.
In case of doubts please contact the after-sales service of your operating company
Danger of accident!
Always mount Sitraffic Sensus Unit in such way that driver's field of vision is not impaired!
Attaching the holder to the windscreen
1. The determined location on the windscreen and the contact surface of the suction
cups must be clean, dry and free from oil and grease. If necessary, carefully clean
with the supplied cleaning cloth and wait until the surface is dry before to proceed
with the next step.
2. Attach the holder at the chosen position with the suction cups. Press firmly at the
centre of each suction cup.
for support.