Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 340

Expansion cards and backup units
8.8.4.2 Removing the DynamicLoM module
"Removing the DynamicLoM module" on page 337
Ê
I
Do not remove the three bolts.
8.8.4.3 Installing the DynamicLoM module
"Installing the DynamicLoM module" on page 333
Ê
8.8.4.4 Concluding steps
Ê If a riser module 1 is installed, remove the riser module 1 refer
the riser module 1 (HL)" on page 85
"Reassembling" on page 73
Ê
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
Ê Inform the customer about changed WWN, MAC addresses and SAS
addresses. For further information, refer to section
MAC / WWN addresses" on page
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 118
"Configuring LAN teaming" on page 124
Ê
"Enabling SVOM boot watchdog functionality" on page 114
Ê
8.8.4.5 Software configuration
Replacing with same DynamicLoM module type
If the DynamicLoM module type remains the same, no additional configuration
is necessary, because the network settings are stored on the system board.
Inform the customer about the changed WWN and MAC addresses.
340
122.
Upgrade and Maintenance Manual
.
"Looking up changed
to"Installing
RX2540 M2