SMSCOM SmartController Manual

SmartController
Manual
5A/1000w

Climate control

The SMSCOM SmartController is designed to maintain a constant temperature inside your room
whilst keeping airflow under control at all times.
Once you have set your desired temperature level, the SmartController will automatically create the
perfect climate.

How it works

The SmartController uses our 'Motion Flow' software system; therefore, it reacts completely
differently to the usual types of controllers.
When you first install the SmartController, it requires 5-10 minutes to scan your room to make an
evaluation for the correct running speed for you fan. After this time, the controller knows the exact speed your fan
needs to run to maintain the temperature. From then on, the SmartController will make automatic
adjustments to the fans' speed to always maintain the set temperature.
The SmartController has over 60 different speed settings, meaning fan speed control is very smooth and
temperature control is the most accurate out of any type of controller.
As well as highly accurate temperature control, this new technology ensures less fan noise and a longer life for
your fan. The SmartController is plug and play, so no wiring is needed. Just plug in your fan, set the desired
temperature and minimum fan speed, and the SmartController will take care of the rest.

Usage

1. Plug the SmartController into an electrical outlet
2. Place the Temperature Sensor in the center of your room
3. Connect your fan to the SmartController
4. Set your desired minimum fan speed**
5. Set your desired temperature
**Minimum Fan Speed: This is the lowest speed that the fan will run at. The lower this speed is set, the greater range
your fan has to operate between. We recommend this is set to its lowest setting. This means the fan will run
anywhere between a slow 'tickover' and full speed to keep the temperature constant. Adjustments to the lowest
speed can be made to suit your fan type if necessary.
Now the Smartcontroller will perform the scan of your room. BE PATIENT! This can take up to 5-10 minutes!!
During the scan, the Smartcontroller will run for a few seconds at 100% and then at its lowest fan speed setting.
After 5 -10 minutes the controller will run at the correct speed and will require no more manual adjustment.
The Smartcontroller will automatically make adjustments as necessary to maintain the temperature.

Important Notice

- Do not mount the Temperature Sensor in the direct airflow of the fan. This is needed to ensure reliable operation.
- Connecting fans that exceeds the 5A/1000Watt power limit causes permanent damage to the device.
- We do not guarantee the damages or risks caused by inadequate operation or beyond product specifications.