Table of Contents
Advertisement
Quick Links
Please read this booklet and keep for future reference for the safe installation and
operation of your:
NAPIER AG
INSTALLATION AND OPERATION GUIDE
AG (Air Guard) stands for Clean Air. This AG Fire can be installed on properties of less than 2
hectares of land and meets with ECAN standards of 0.9g and 66% efficiency.
AUTHORISATION NUMBER 201339
This Fire must be installed by someone competent to do so, Firenzo recommend the use of a
NZ Home Heating Association, solid fuel Fire installation technician (SFAIT), or other suitably
qualified person. The Fire and Flue System must be installed in accordance with AS/NZS2918.
All installations must be in accordance with these instructions. Consult with the building authority
having jurisdiction to determine the need for a permit prior to commencing the installation.
Failure to follow these instructions may also void your fire insurance and warranty.
This Fire has been tested to Appendix E & B of the joint Australia/New Zealand Standard
2918:2001.
This Fire Conforms with ECAN requirements.
Napier Installation—March 2019
Advertisement
Table of Contents
Related Manuals for Firenzo Woodfires NAPIER AG
Summary of Contents for Firenzo Woodfires NAPIER AG
- Page 1 Please read this booklet and keep for future reference for the safe installation and operation of your: NAPIER AG INSTALLATION AND OPERATION GUIDE AG (Air Guard) stands for Clean Air. This AG Fire can be installed on properties of less than 2 hectares of land and meets with ECAN standards of 0.9g and 66% efficiency.
- Page 2 INDEX Page No: Item No: Topic: Warnings Installation Responsibilities Floor Protector Requirements Installation Clearances Assembly Instructions Flue Installation Flue System Minimum Height Operating Instructions Operating Instructions Operating Instructions Operating Instructions Warranties Warranties Warranties Your Warranties Registration Card is enclosed, please complete and return to us. Under our policy of continuous product improvement, Firenzo reserves the right to alter specifications or product from that shown.
- Page 3 1. WARNINGS This Fire should be maintained and operated at all times in accordance with these instructions. The Napier is tested to N.Z. Standards AS/NZS 2918:2001. If this Fire is incorrectly installed a house fire may result. For your safety follow the installation instructions carefully.
-
Page 4: Installation Responsibilities
2. INSTALLATION RESPONSIBILITIES Warning: The Fire and Flue System shall be installed in accordance with AS/NZS 2918 and the appropriate requirements of the relevant building code or codes. Any modification of the Fire that has not been approved in writing by the testing authority is considered to be in breach of the approval granted for compliance with AS/NZS 4013. -
Page 5: Installation Clearances
4. INSTALLATION CLEARANCES Firebox Size: Height 550mm Fireboxwith Logbox: Logbox Only Width 440mm Height 640mm Height 310mm Depth 350mm Width 440mm Width 330mm Flue Size: 150mm Depth 350mm Depth 250mm Heating Area estimate 150sqm Overall Height 840mm All Clearances shown are from the EDGES OF THE CAST TOP of the Napier CLEARANCES... - Page 6 5. ASSEMBLY INSTRUCTIONS 1. Remove all outer packaging. 2. Position Fire onto floor protector ensuring it complies with the clearances as shown section 4 on page 5. 3. Lift top casting and ensure baffle bricks and metal deflector are correctly located as per diagrams below and then replace top casting ensuring good seal down onto fire rope bed.
- Page 7 6. FREESTANDING FLUE SYSTEM INSTALLATION INSTRUCTIONS Position Fire on floor protector ensuring all Fire clearances are correct as per clearances on page 5. Once the location is confirmed, the Fire and floor protector shall be fixed to the floor itself (refer to page 4 &5). Extend a plumb line from the centre of the Fire flue spigot to the ceiling.
- Page 8 FLUE SYSTEM MINIMUM HEIGHT NOTES: The flue shall extend not less than 4.6m above the top of the floor protector. The flue cowl must be at least 600mm above the highest point of the roof if within 3 metres of it, or 1 metre above the roof penetration if more than 3 metres from the ridge.
- Page 9 7. OPERATING INSTRUCTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING ANY FURTHER. PLEASE KEEP THIS BOOK IN A SAFE PLACE. FIRST BURN: On the INITIAL LIGHTING ONLY, the high temperature paint used on your Fire will give off smoke and odour for several hours. As this is a temporary condition, open doors, windows, etc. to give adequate ventilation.
-
Page 10: Flammable Liquids
RE-LOADING AFTER AN EXTENDED BURN TIME At the end of an extended burn, re-establish the fire by adding a few small split logs, adjust the Control to ‘High’ and allow the firebox temperature to build up before adding the balance The addition of large quantities of cold fuel to a low fire will reduce the firebox temperature dramatically and this may result in ‘losing’... -
Page 11: Door Glass
8. DOOR GLASS The Napier is equipped with a self-cleaning glass air wash system. A discolouration can form after a long ‘low’ burn, but 30 minutes of ‘high’ burn should clear it from the glass. Clean glass with wet newspaper dipped in ash from the firebox, then wipe glass. Do NOT clean the glass while hot. -
Page 12: Fire Bricks
SECONDARY AIR TUBE: The Secondary Air Tubes are a consumable item and are serviceable. Please check on a regular basis for wear and tear. FIRE BRICKS: The internal fire bricks on the sides and base of the firebox can crack in extreme heat. However they are safe to leave as is until they start to crumble in which case they should be replaced. - Page 13 11. WARRANTIES Terms applicable to Firenzo Wood fires’ warranties (current as at 29 May 2015) 1. Hewitsons Limited (company number 569753) with a specified address of 98 Niven Street, Onekawa, Napier (Firenzo) and trading as Firenzo Wood fires gives: - a ten (10) year warranty but ONLY for the steel firebox, fascias and cast iron components of all Firenzo wood fires.
- Page 14 10. For information (including claim procedures) concerning potential claims, potential warranty claimants should contact: in the first instance, the retailer/dealer from whom the Firenzo wood fire was originally purchased; or (if the retailer/dealer is not contactable or does not address the claim to the claimant’s satisfaction) Firenzo at the specified address, including as appropriate to arrange an inspection of the Firenzo wood fire.
- Page 15 16. No person other than a designated accredited agent can bind Firenzo with respect to Firenzo’s obligations under the warranties, and then only in accordance with the agent’s actual authorities. A person is a designated accredited agent where they are identified and certified in writing by Firenzo to be such with their authorities specified in the certificate.
- Page 16 WOODFIRES FIRENZO Manufacturers of: Free standing Bronte Contessa Encore Lady Kitchener Napier Viking Vision Insert Aqualux Athena Bay & Flush Forte Bay & Flush Kompact Athena Kompact Deco Kompact Diva Kompact Forte Kompact Plaza Kompact Serenity Topaz 98 Niven Street PO Box 3231 HB Mail Centre Napier 4142...
Need help?
Do you have a question about the NAPIER AG and is the answer not in the manual?
Questions and answers