Installation - Miele G 7764 SUPER-COMBI Operating Instructions Manual

Installation

Please refer to the installation diag-
ram supplied with this machine
The machine must be installed cor-
rectly and levelled accordingly.
Any unevenness in the floor level can
be compensated for by adjusting the
screw feet.
The machine can be installed in the fol-
lowing ways:
Free-standing
Slot-in or at the end of a row:
The dishwasher should be installed ad-
jacent to other appliances and furniture
or in a recess at least 60 cm wide and
60 cm deep.
Built under:
The dishwasher should be installed
under a worktop run or under a drain-
ing board.The recess should be at
least 60 cm wide, 60 cm deep and 82
cm high.
To do this the machine lid must be
removed as follows:
Open the door
Remove the fixing screws on the left
and right using a cross-headed
screwdriver.
Pull the lid approximately 5 mm for-
wards, lift and remove.
Without the lid the dishwasher can be
built into a recess 82 cm high.
If building the dishwasher into a recess
87 cm high, a conversion kit is re-
quired.
Adjust and secure the dishwasher
To guarantee stability, the dishwasher
must first be aligned and then screwed
to the worktop.
Open the door.
Through each of the two holes in the
front rim, left and right, screw the
dishwasher to the front edge of the
continuous worktop.
Installation
31