Table of Contents
Advertisement
directly from the mains. Simply connect the
appliance to the mains.
Charging with the supply unit
1
Make sure the appliance is switched off (Fig. 3).
2 Insert the small plug into the appliance (Fig. 4).
3 Put the supply unit in the wall socket.
4 When the appliance is charging, the charging
light lights up continuously (Fig. 5).
5 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Optimising the lifetime of the
rechargeable battery
When you have charged the appliance for the first
time, we advise you to use it until the battery is
completely empty. Continue to use the appliance
until the motor almost stops operating during a
session. Then recharge the battery. Follow this
procedure at least twice a year.
Using the appliance
The hair length settings are indicated in
millimeters, the comb cuts the hair to a length of
1mm to 23mm. The settings correspond to the
remaining hair length after trimming.
Warning: Be careful when you trim for the first
time. Do not move the trimmer too fast. Make
smooth and gentle movements.
Tip: Start trimming at a high length setting and
reduce the length setting gradually until you have
reached the desired hair length.
Trimming with the trimming comb
1
Attach the trimming comb to the appliance (Fig.
6).
2 slide the length setting adjustment slider to the
desired length setting (Fig. 7).
Note: When you trim for the first time, start at
the highest length setting to familiarise yourself
with the appliance.
3 Switch on the appliance (Fig. 8).
4 Move the appliance slowly and with light
pressure against the direction of hair growth
(Fig. 9).
Note: Make sure that the flat part of the comb
always stays in contact with the skin to obtain
an even result (Fig. 10).
Trimming with the kids comb
Note: Use the kids comb for trimming kids hair only.
1
Attach the kids comb to the appliance (Fig. 11).
2 Slide the length setting adjustment slider to the
desired length setting (Fig. 12).
Note: When you trim for the first time, start at
the highest length setting to familiarize yourself
with the appliance.
3 Switch on the appliance (Fig. 8).
4 Move the appliance slowly and with light
pressure against the direction of hair growth
(Fig. 13).
Note: Make sure that the flat part of the comb
always stays in contact with the skin to obtain
an even result (Fig. 10).
Trimming without comb
Use the trimmer without the trimming comb to trim
hair close to the skin (0.5 mm) or to contour the
neckline and sideburns.
Caution: Be careful when you trim without comb
because the cutting unit removes every hair it
touches.
1
Pull the comb off the appliance (Fig. 14).
2 Switch on the appliance (Fig. 8).
3 Touch the hair lightly with the trimmer. Make
well-controlled movements (Fig. 15).
Cleaning
Warning: Never use scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Warning:Never immerse the appliance in
water, or rinse it under the tap.
Note: Only the cutting element and the comb can
be cleaned with water.
1
Make sure that the appliance is switched off
and disconnected from the mains.
2 Wipe the housing of the appliance with a dry
cloth.
3 Remove the comb. Clean it with the cleaning
brush and rinse with water (Fig. 16).
4 Press the release button. The cutting unit
comes off the appliance (Fig. 17).
5 Clean the cutting unit with the cleaning brush or
rinse it under the tap (Fig. 18).
6 Clean the inside of the appliance with the
cleaning brush (Fig. 19).
7 Shake off excess water. To reattach the cutting
unit, insert the lug of the cutting unit into the
guiding slot.
8 Insert the lug of the cutting unit into the guiding
slot and push the cutting unit back onto the
appliance (Fig. 20).
Replacement
Only replace a worn or damaged cutting unit with
an original Philips cutting unit, available from
authorised Philips service centre.
1
Press the release button. The cutting unit
comes off the appliance (Fig. 17).
2 Insert the lug of the new cutting unit into the
guiding slot and push the cutting unit onto the
appliance (Fig. 20).
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the
international warranty leaflet for contact details).
Advertisement
Table of Contents
