Advertisement
Harpoon Lagoon Marquee Install Guide
Step 1: Unlock and open both player one and player two control panels. Located at the left-
most and rightmost are two spin knobs. Spin the knobs counter-clockwise until they can be
removed. Put aside. Lift the cabinet top up. Adjust the upper mounting bracket from it's
down position to it's up position (see below). Slide the game over the marquee support assem-
bly as shown. Attach the cabinet bracket to the game using two 1/4-20 1 1/2" bolts and two
5/16 - 1/4 washers.
1
Advertisement
Table of Contents
Related Manuals for Ice Harpoon Lagoon Marquee
Summary of Contents for Ice Harpoon Lagoon Marquee
- Page 1 Harpoon Lagoon Marquee Install Guide Step 1: Unlock and open both player one and player two control panels. Located at the left- most and rightmost are two spin knobs. Spin the knobs counter-clockwise until they can be removed. Put aside. Lift the cabinet top up. Adjust the upper mounting bracket from it’s down position to it’s up position (see below).
- Page 2 Harpoon Lagoon Marquee Install Guide Step 2: Open each side’s coin doors and locate the bolt slots shown below. Attach the cabinet on each side with a 5/16 x 1 3/4 bolt, 1 1/2 - 2”washer and 1 1/4” washer on each side. The cabinet is now securely fastened to the marquee support assembly.
- Page 3 Harpoon Lagoon Marquee Install Guide Step 4: Attach the video and power cables. HDMI cable goes here. AC Plug goes here.
- Page 4 Harpoon Lagoon Marquee Install Guide Step 5: Attach the monitor assembly with four 1/4-20 1 1/2” bolts and washers. Note, only one side is shown. STEP 6: Using two 1/4-20 1 1/2” bolts attach the upper monitor assembly. IMPORTANT: Do not attach these bolts until the lower bolts are attached first.
- Page 5 Harpoon Lagoon Marquee Install Guide Step 7: Attach the clear upper plaque using two 1/4-20 2” bolts, washers, and two keep nuts. Step 8: Located at the bottom of the marquee support assembly are access doors. Open the ac- cess door to locate the power module. The AC cord can be run either by the hole located at the bottom of the marquee support bracket or to the side of it.
- Page 6 Harpoon Lagoon Marquee Install Guide Final Step: Insert three Phillip screws (6068) as shown. At the back use three washers (6020) and Nylon nuts (6072) to attach the shark front onto the monitor assembly. Connect the AC plug as shown. Now attach the two BLACK screws to the top as shown below.
- Page 7 Harpoon Lagoon Marquee Install Guide To access the bulb to the shark, remove the two upper black screws before unlocking the door.
- Page 8 Harpoon Lagoon Marquee Install Guide A USB flash drive is included along with the mounting hardware. Insert the flash drive before applying power to your marquee. The flash drive plugs into the media player as shown below.
Need help?
Do you have a question about the Harpoon Lagoon Marquee and is the answer not in the manual?
Questions and answers