ITW Diagraph PA/6000 User Manual page 16

Diagraph - an ITW Company PA/4600 & PA/6000 User Manual
Step 4 - Configure the One Time Settings (OTS)
Goal:
Enter the One Time Settings screens and select the configuration of this particular system.
Note:
Most of these items were determined when the unit was assembled; so only configurations
that have changed require this adjustment.
Note:
These selections can only be accessed when the unit is first powered up. This can be done
when the power is first applied, or when the unit is taken out of
Map:
Power On
Once the first OTS screen is entered, follow the setup steps outlined in the
Setting (OTS) Screens on page 26
Step 5 - Enter Values for the System Settings
Goal:
Enter System information pertaining to Application Mode, Serial Baud Rate, and Passcode.
Map:
Beginning in the Offline mode, press the Settings button. From the Settings Menu, which
can be passcode protected (default passcode from the factory is 9999), select the System
button choice. This enters the System Menu selections. See section
Screens on page 27
For a typical one tamp application, the following settings provide a good start:
•
Apply Mode
•
Baud Rate
•
Passcode
Setup
.
for information on how to make these selections.
1 Tamp
19,200
0000
Page 15
StandBy .
One Time
System Settings