Download Print this page
Sealey LFT03 Instructions For Use

Sealey LFT03 Instructions For Use

Aluminium loft ladder

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
1.1
GENERAL SAFETY
WARNING! Ensure Health and Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
F
Familiarise yourself with the application and limitations of the ladder, as well as the potential hazards.
!
Maintain the equipment in good condition.
!
Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
!
Keep the work area clean, uncluttered and ensure there is adequate lighting.
!
WARNING! Rest the base of the ladder on level and solid ground.
F
WARNING! Never over-reach when on the ladder.
F
Keep children and unauthorised persons away from the working area.
!
DO NOT use the ladder for any purpose other than that for which it was designed.
%
DO NOT use the equipment if any parts are damaged or missing as this may cause failure and/or personal injury.
%
DO NOT allow children to climb the ladder.
%
DO NOT use the equipment when you are tired, under the influence of alcohol, drugs or intoxicating medication.
%
When not in use, stow securely.
!
2.
INTRODUCTION
Aluminium loft ladder manufactured to BS7553:1992 class G. Complete with hand rail and all fixings with factory assembled components for
quick and easy installation. 3-Section design enables ladder to fit in smaller areas than standard 2-section ladders.
3.
CONTENTS & SPECIFICATION
A
B
C
3.1 Contents:
Included with the ladder you should find:
A
3 x washers
B
6 x screws (31mm)
C
2 x nuts
D
2 x screws (64mm)
E
8 x screws (15mm)
F
2 x screws (18mm)
G
Pole (for opening trap door and lowering ladder)
H
Hand-rail
I
Fixing pins/screws and marker for auto latch
J
Trap door hinges
K
Auto latch
L
Stabilisers/retainers for hand rail
3.2 Specification:
No. of sections
Max floor to floor
Min loft clearance
Min loft opening
Max load
E
F
D
3
3m (see fig )
1050mm
432 x 508mm
100kg (15.7 stone)
INSTRUCTIONS FOR:
ALUMINIUM LOFT LADDER
Model No.:
I
G
H
fig 1
3m (max)
LFT03
J
K
L
LFT03 - 1 - 130104

Advertisement

loading

Summary of Contents for Sealey LFT03

  • Page 1 LFT03 Model No.: Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
  • Page 2 Fit the striker plate using the screws provided and test the position by opening and closing the trap door until you are satisfied with its operation. Ensure all screws are tightened and fix the two pins provided, into the latch. LFT03 - 1 - 130104...
  • Page 3 Ensure the guide assembly is well lubricated and free to move correctly. Check the ladder thoroughly for signs of damage/wear before and after each use. If you suspect the ladder may be damaged/weakened in any way, remove it from service immediately and contact your authorised Sealey dealer for repairs/replacement. PARTS Part No.