Error Codes - Sparx Operating Manual

For all errors, an error code is displayed on the
these error codes will either be permanently or temporarily displayed. If an error code was temporarily
displayed and you want to see it again, retrying the action without fixing the underlying cause will display the
error. Permanent error codes require the user to acknowledge the error before the error will be resolved and
operation can continue. Permanent Error Codes will also be stored in the Error History (discussed below). The
troubleshooting table below suggests corrective actions to resolve the error.
If the user wishes to cycle through previous permanent Error Codes, hold down the
seconds until a tone is heard (button initially emits an "error" tone when pressed). Once the beep is heard, the most
recent Error Code is displayed. Pressing the
ERROR CODE
1 - 2 - 10 Air Filter missing.
Attempted to start
1 - 3 - 10
Grinding Ring installed.
1 - 4 - 5
Pressed the p Play Button
1 - 4 - 6
Pressed the p Play Button
2 - 3 - 6 Sharpener failed to detect skate.
Grinding Ring has insufficient life remaining for
2 - 4 - 6
selected sharpening operation.
2 - 4 - 10 Grinding Ring empty.
2 - 5 - 6 Grinding Ring not found.
2 - 5 - 10 Grinding Ring read incomplete.
2 - 6 - 10 Grinding Ring read error.
3 - 5 - 10 Grinding motor overcurrent.
3 - 4 - 10 Hardware Fault Circuitry failure.
3 - 6 - 10 Translation Error - Limit undetected.
4 - 5 - 10 File System Incompatibility

eRROR CODeS

Cycle Counter
l Left and
CAUSE
Alignment Mode with skate or
in Alignment Mode.
in Move Mode.
(1-2-4 is being displayed in the figure above),
n Cancel Button
r Right Buttons will cycle through previous Error Codes.
CORRECTIVE ACTION
Install Air Filter.
Remove skate and install Alignment
Exit Alignment Mode by pressing the
Button prior to pressing the p Play
Exit Move Mode by pressing the
prior to pressing the p Play button.
Ensure that skate is installed in the
Grinding Ring height is adjusted properly.
Sharpener will reset Cycle Count
sharpener with the new value or lower.
Install a valid Grinding Ring.
Install a valid Grinding Ring.
Repeat process and allow extra time between steps. If this does not
resolve the problem, replace the
Install a valid Grinding Ring.
Confirm that the Grinding Ring height is adjusted properly and nothing is
obstructing the Grinding Ring.
Call Customer Support at 1-855-SPARX HQ (1-800-772-7947).
Carriage
Confirm that the is not obstructed.
The installed Grinding Ring is not compatible with the skate sharpener.
Install a valid Grinding Ring.
for 2
Ring.
c Alignment Button or n Cancel
button.
m Move Button or n Cancel Button
Skate Clamp
correctly and the
to maximum available cycles. Run
Grinding Ring.
tROUBLeSHOOtING
25