Electrical Safety Components; Maintenance - Xpelair Premier DX200 Installation And Maintenance Instructions Manual

Electrical safety components

♦
Baffle plate 1 must always be fitted
when the fan is operational.
♦
Blanking plates 8 must not be removed
unless directed to do so when the flat
ducting adaptor is fitted.
Before making electrical connections
pierce grommet with No. 2 pozi-drive
screwdriver.
DO NOT REMOVE GROMMET.

Maintenance

A QUALIFIED ELECTRICIAN MUST CARRY
OUT ALL CLEANING.
♦
Before cleaning, isolate the fan
completely from the mains electricity
supply. Allow 3 minutes for the impeller
to stop rotating.
1 Remove the baffle plate 1 by unclipping
it using a sideways action.
2 Clean the baffle plate 1 by immersing in
warm soapy water. Dry thoroughly.
3 The front cover 2 and surround 9
should be wiped clean with a damp cloth.
4 Refit the baffle plate 1 onto the front
cover 2 by locating the clips and
carefully snapping into position. Do not
immerse the fan in water or any other
liquids. The bearings are lubricated and
sealed during manufacture and require no
further attention. Regular cleaning of
your product is recommended.
♦
Never use strong solvents to clean the
fan.
♦
Apart from cleaning, no other
maintenance is required.
♦
Do not immerse the fan in water or
other liquids to clean any other parts of
the fan.
Terminating the ducting
For E and F
1Baffle Plate
2Front Cover
3Rating Plate
4Spindle Plugs
5Fan Box
6Terminal Cover
7Circular Spigot
8Rectangular Blanking Plate - 2 off
9Surround
!ºFan Body Clamps - 3 off
!¡Clamps Screws and Wall Plug Screws
40mm long - 3 off
!™Ceiling Screws 25mm long - 4 off
!£Surround Support Plates - 3 off
9