Care Of Accessories; Fuse Replacement - Endecotts Sonic Sifter User Manual

Maintainance
_______________________________________________________

Care of Accessories

The Fines Collector and Diaphragm should be cleaned with a mild detergent. Do
not use solvents of any kind as this will cause disintegration and failure of the
Latex parts. After the Fines Collector and Diaphragm have dried, dust lightly with
fine talcum powder and store in a cool, dry place. Avoid heat and direct sunlight
on all the Latex parts.
All spacers and the Top Cone may be cleaned in the ultrasonic bath used for sieves
in the same place as the sieves and accessories. Avoid heat and direct sunlight.
Fuse
Should either of the fuses require replacement they must be of the identical type
and rating as the originals. The rating and the type are marked on the yellow
warning label at the rear of the unit. Switch off the mains supply at the local outlet
and remove the IEC mains connector at the rear. Remove the holder and fuses from
the combined IEC inlet fuseholder with a suitable tool. Test the fuses and replace
any which have blown.
All replacement parts must be ordered by quoting the serial number of the
machine and the correct part number. Part number can be obtained from our
sales or technical department
- 14 -