Overfill Protector; Storing Your Dishwasher - Whirlpool 900 Series Use And Care Manual

Overfill protector

The overfill protector (in the front right corner
of the dishwasher tub) keeps the dishwasher
from overfilling. It must be in place for the
dishwasher to operate.
Check under the float for objects that may
keep the protector from moving up or down.

Storing your dishwasher

Moving or winterizing your
dishwasher
Protect your dishwasher and home against
water damage due to freezing water lines. If
your dishwasher is left in a seasonal dwell-
ing or could be exposed to near freezing
temperatures, have a qualified person do
the following:
1. Disconnect power or unplug dishwasher.
2. Turn off water supply to the dishwasher.
3. Remove the 4 screws on the lower
access panel and remove the lower
access panel.
4. Place a shallow pan under the water
supply valve. Then, use a wrench to
disconnect the water inlet from the water
supply valve. Separate the water inlet
from the water supply valve and drain
water into the pan.
5. Remove the spring clamp from the water
outlet and separate from the water
supply valve; drain water into pan.
6. Reconnect both water inlet and water
outlet to the water supply valve.
7. Empty the pan and reposition it under
the water pump.
8. Remove the clamp and disconnect the
drain hose from the water pump; drain
water into pan.
9. Reconnect drain hose to the water
pump, being sure to position the clamp
over the connection.
10. Replace the lower access panel.
C A RI NG F OR YOU R DISH WASHER
Water outlet
Spring
clamps
Water supply Water
valve inlet
continued on next page
Drain
hose
Water pump
and motor
21