Connect To Water Supply - Midea MDT24H3AST Installation Instructions Manual

6.
Connect the wires as follows using UL listed wire nuts of the
appropriate size to connect power cord to 16-gauge dishwasher wire.
NOTES:
•
Use cUL/UL listed wire nuts of the appropriate size
to connect the power cord to 16-gauge dishwasher
wiring.
•
Insert wire ends into the wire nut. Do not pre-twist
bare wire.
•
Twist the wire nut.
•
Gently tug on wires to be sure both wires are
secured.
a
7.
Tighten strain relief screws to secure the power cord.
8.
Gently guide the wire nuts into the junction box, and then replace the
junction box cover making sure to not pinch the wires.

CONNECT TO WATER SUPPLY

IMPORTANT: Handle and reposition the copper tubing gently; it bends
26
and kinks easily.
1.
Connect the water supply line to the 90° elbow.
•
Slide the nut onto copper tubing, approximately 1" (2.5 cm) from
the end, and then slide the ferrule onto the tubing. Do not position
the ferrule on the end of the tubing.
•
Insert the copper tubing into the elbow as far as it will go.
Power supply wire:
white
black
ground wire
b
c
Terminal box wire:
white
black
ground connector
a
b
c
Ground
White
Black