Policy Config-Sync Prc Reload - Cisco WLC 5700 Series Command Reference Manual

High Availability Commands

policy config-sync prc reload

To reload the standby switch if a parser return code (PRC) failure occurs during configuration synchronization,
use the policy config-sync reload command in redundancy configuration mode. To specify that the standby
switch is not reloaded if a parser return code (PRC) failure occurs, use the no form of this command.
policy config-sync {bulk| lbl} prc reload
no policy config-sync {bulk| lbl} prc reload
Syntax Description
bulk
lbl
Command Default
The command is enabled by default.
Command Modes
Redundancy configuration
Command History
Release
Cisco IOS XE 3.2SE
Examples This example shows how to specify that the standby switch is not reloaded if a parser return code (PRC)
failure occurs during configuration synchronization:
Controller(config-red)# no policy config-sync bulk prc reload
OL-32317-01
Specifies bulk configuration mode.
Specifies line-by-line (lbl) configuration mode.
Modification
This command was introduced.
High Availability Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
policy config-sync prc reload
15