Troubleshooting - Stannah MICROLIFT User Handbook Manual

TROUBLESHOOTING

Check this list before contacting your local Stannah Service Branch - it could save you time and
the cost of an unnecessary service call.
Problem
Lift does not operate
and red indicator light
remains on.
No indicator lights and
lift will not operate on
push buttons.
Lift operates but indicator
lights do not operate.
Lift does not stop at
serving level
Motor rotates but lift car
remains stationary.
* A blown indicator bulb will not affect the operation of the lift. Please be aware that you will incur a
charge if you call out the Stannah Service Branch to replace blown indicator bulbs between service visits.
The indicator bulbs will normally be replaced as a matter of routine at the next maintenance/service visit
- check with your Service Branch to find out when your next visit is due.
For your local Stannah Service Branch - see page 22
18
Cause
Inner car shutter and/or landing
door left open.
Lift stopped below serving level
due to overloading
Over travel timer tripped due to
goods falling from the lift car and
causing the lift to jam.
Power off
Overload tripped
Fuse in isolator blown
Fuse E1 in controller blown
Indicator bulbs blown *
Lift over travelled
Lift car or balance weight tight in
guides
Goods fallen from the lift car
causing the lift to jam.
Cure
Check all landing doors and
inner car shutter doors are
properly closed on all floor
levels
Call Stannah Service Branch
Call Stannah Service Branch
Switch power on
Call Stannah Service Branch
Replace 15 Amp fuse(s) in
isolator if necessary
Call Stannah Service Branch
Call Stannah Service Branch
Call Stannah Service Branch
Call Stannah Service Branch
Call Stannah Service Branch